Sometimes
referred to as Zamac Nail in Anchors , they are made from corrosion
resistant ZAMAC alloy and can be used in concrete, block, brick or
stone. Hammer Drive anchors are installed in pre-drilled holes with a hammer strike
that drives a nail into the anchor body, expanding the anchor to form a
tight fit. These anchors secure light loads to masonry materials.
1-1/4in. x 1/4in. Hammer Drive anchors - Stainless Steel Pin
Installation:
- Drill
a hole in base material using a carbide drill bit the same diameter
as the nominal diameter of the anchor to be installed.
- Drill the hole to specified embedment depth, plus 1/4in. for pin extension, and blow hole clean using compressed air.
- Position fixture and insert Hammer Drive anchor.
- Tap with hammer until flush with fixture, then drive pin until flush with top of head.
- Made from corrosion resistant ZAMAC alloy
- Used with Concrete, Block, Brick or Stone
- Easily hammered into pre-drilled hole
- Virtually tamperproof
- ZAMAC Body with Stainless Steel Nail
- ASTM B633, SC1, Type III
- Not for use in overhead applications
Also available Zinc Plated Steel Nail